Check Point 61000 Wartungshandbuch PDF herunterladen (Seite 28)

Connecting a Management Console

Step 5: Initial Software Configuration Page 28

Step 5: Initial Software Configuration

When installing and configuring the 61000 Security System, start with the Security Gateway Module furthest

to the left in the chassis. After the first SGM is configured, installation and configuration settings are

automatically propagated to all other SGMs in the defined security group. The Security Group is the group of

SGMs that make up the Security Gateway.

Note - In SmartDashboard, one Security Gateway object represents the SGMs in the

security group.

Connecting a Management Console

1. Connect the RJ-45 jack end of a serial cable to the console port on the left-most Security Gateway

Module in the chassis.

2. Connect the other end of the serial cable to the computer that you will use to do the initial configuration

of the 61000 Security System.

3. On the configuration computer, connect to the 61000 Security System using a terminal emulation

application such as PuTTY.

 Make sure the Speed (baud rate) is set to 9600

 No IP address is necessary

4. Log in with username: admin and password: admin.

Performing the Initial Setup

1. To start the installation wizard run #setup

2. In the Welcome screen, press a key.

3. Select Set SGMs for Security Group

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 46 47

Keine Kommentare

Check Point 61000 Wartungshandbuch Seite 28