Check Point 61000 Wartungshandbuch PDF herunterladen (Seite 33)

Confirming the Software Configuration

Licensing and Registration Page 33

Licensing and Registration

61000 Security Systems have an initial 15-day evaluation license. After the evaluation license expires, you

must license and register the system.

Each chassis is licensed separately. If you have dual chassis system, you must install two licenses.

The license key (CK) is the chassis serial number. The chassis serial number is printed on the chassis

sticker. You can also retrieve the chassis serial number from the CCM.

To retrieve the serial number from the CMM:

1. Connect to one of the SGMs on the chassis.

2. Get the IP address of the CMM by running (from gclish): show chassis id all module CMM1

ip.

3. Using the IP address, open an ssh connection to the CMM.

4. On the CMM, run: clia fruinfo 20 254.

5. The output shows the Chassis Serial Number.

To license and register the 61000 Security System

1. Open the User Center Registration page (http://register.checkpoint.com/cpapp ).

2. Search for the chassis serial number.

3. Generate a license based on the IP address of the SSM interface connected to your Security

Management server

Note - Because the 61000 Security System has single Management IP address, in

dual chassis environments, the Active and Standby chassis should be bound to the

same IP address in the license. Generate two licenses and enter the same IP

address in each license.

4. Install the license on the system.

 If you use the cplic command, run it from gclish so that it applies to all SGMs.

 Run cplic twice if you have a dual chassis environment.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 46 47

Keine Kommentare

Check Point 61000 Wartungshandbuch Seite 33