Check Point 61000 Wartungshandbuch PDF herunterladen (Seite 39)

Monitoring Key Performance Indicators and Load Statistics (asg perf)

Monitoring and Configuration Commands Page 39

Output

Comments

 The (number/ number) convention presents the number of components

actually up set against the number of components required to be up. For

example SGMs 3 / 3 means that 3 SGMs are up and 3 are required to be up.

 Chassis grade is the sum of the grades of all components. The grade of

each component = One Unit Weight x the number of components that are

UP. The One Unit Weight of each component can be configured to reflect the

importance of the component in the system. To configure the One Unit Weight

run:

set chassis high-availability factors <sensor name>

 Minimum threshold for traffic processing - The minimum grade

required for the chassis to become ACTIVE.

 Minimum grade gap for chassis failover - Chassis failover occurs

to the chassis with the higher grade only if its grade is greater than the other

chassis by more than the minimum gap.

 Synchronization - The status of synchronization:

 Within chassis- between SGMs located in the same chassis.

 Between chassis - between SGMs located in different chassis.

 Exception Rules - user configured exception rules. To configure, use

the command g_sync_exception.

Monitoring Key Performance Indicators and

Load Statistics (asg perf)

Description

Use this command to continuously monitor key performance indicators and load

statistics.

Syntax

asg perf [-b blades][-v][-p][-a][-k]

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Keine Kommentare

Check Point 61000 Wartungshandbuch Seite 39